MSI - Wiki

  • Increase font size
  • Default font size
  • Decrease font size

Why do I have to correct my Depth frequently?

E-mail Print PDF

Why do I have to correct my Depth frequently?

______________________________________________________

A:

TEL RTU

If you are using a two-point calibration

1. Check the Depth Calibration

a. Go to Setup → Depth → Configuration

b. Go to the Linear tab

c. Type the correct Calibration in to the Counts Per Foot: textbox

d. Click on the Calibrate button

e. Click Yes → OK → Close

If you are using a three-point calibration

1. Use a two-point calibration that will work until you can perform another three-point calibration

2. Use the steps shown in the two-point Calibration above

If the problem still exists, check the encoder

1. Check the encoder card with the troubleshooting instructions in the Equipment Manual

2. Restart the TEL side into the TEL RTU from HUTIL

MiniRTU

Use the steps in the Empty Drill Views section

1. Check the Depth Calibration

2. Go to Setup → Depth → Configuration

3. Go to the Linear tab

4. Type the correct Calibration in to the Counts Per Foot: textbox

5. Click on the Calibrate button

6. Click Yes → OK → Close

If the problem still exists, check the encoder

Check the encoder card with the troubleshooting instructions in the MiniRTU FAQ